Brand:

- The CBT-500 Cable Tester by Hosa Technology
- diagnoses signal failure in cables terminated
- with any combination of XLR, Phone, Phono, and
INV#116204

- Includes a microphone, a speaker, a test tone generator
- Outputs for standard headphones
- 1/4" jack for line-in or a 2k Ohm (telephone) earpiece out
- For an instant hands-free intercom, just plug in headphones and hook up one Qbox on each end of a line and use the built-in microphone.
- Use it to monitor a standard 3-wire intercom feed - LEDs confirm the presence of intercom or phantom power.
- Use it as a squawk box to the stage from the main audio console during set-up.
INV#35250

- Advanced cable testing unit w/split design,
- Allowing users to test the cable at the plug-in
- Source
INV#168431

- CHECK MATE CALIBRATOR: conforms to IEC 60942 2003
- Class 2, weighs .41lbs, calibration level 94dB &
- 114 @ 1kHz, fits, 1", 1/2", & 1/4" diameter mic
INV#56883

- CRICKET POLARITY TEST SET: Checks continuity and
- Polarity; TRS and XLR in/out; Tests speakers,
- Mics, cables and wireless systems; Tests mixers
INV#37555

- The new design of the HS7 includes the convenient mic stand insert on the bottom of the unit. This
allows a quick setup on top of a mic stand, with the HS7 angled upward for accurate vocal monitoring. - The included mic stand adaptor insures a more stable and secure placement on any mic stand.
- Molded-in yoke bracket points. With the optional yoke bracket assembly the HS7 can be mounted to
a wall or ceiling, or attached to a mic stand. - Microphone boom attachment on top of the HS7 eliminates the need for a second mic stand for your
microphone. (Requires optional hardware). - Integrated handle into the top of the enclosure.
- Each Hot Spot 7 comes equipped with two Twist-lock 1/4" Combo speaker jacks, all of which are wired in parallel to allow easy "daisy chaining'
of multiple Hot Spots. - Mounts to the top of the PA6S, PA6SR, OR HS7
- Allows mic boom to be mounted on top of the unit.
- Works With 3/8" & 1/2" mic booms
- The new design of the HS7 includes the convenient mic stand insert on the bottom of the unit. This
allows a quick setup on top of a mic stand, with the HS7 angled upward for accurate vocal monitoring. - The included mic stand adaptor insures a more stable and secure placement on any mic stand.
- Molded-in yoke bracket points. With the optional yoke bracket assembly the HS7 can be mounted to
a wall or ceiling, or attached to a mic stand. - Microphone boom attachment on top of the HS7 eliminates the need for a second mic stand for your
microphone. (Requires optional hardware). - Integrated handle into the top of the enclosure.
- Each Hot Spot 7 comes equipped with two Twist-lock 1/4" Combo speaker jacks, all of which are wired in parallel to allow easy "daisy chaining'
of multiple Hot Spots. - Mounts to the top of the PA6S, PA6SR, OR HS7
- Allows mic boom to be mounted on top of the unit.
- Works With 3/8" & 1/2" mic booms
INV#98631

- Cable tester w/many common connectors such as
- Speaker Twist, XLR, Phono, BNC, DIN, TRS, TS,
- DMX, & Banana
INV#197938